Tarzan Kit – Shield NOT Included

Tarzan Kit – Shield NOT Included

1 1/2″ Wide Nylon Webbing Strap for a low cost DIY back shield upgrade to any shield.

Tarzan Strap Installation Instructions

1. Take the cover off your shield
2. Use a yardstick or something long and straight to mark two opposing lines, each about 3″ to the edge
3. Use a knife to slice a cut in the shield just as wide as your strap
4. Reinforce around the cut with 4 strips of tape, on both sides of the shield
5. Feed your strap through with something flat, maybe a ruler.
6. Leave the open tail ends on the strap on the inside of the shield
7. Feed them through your buckle
8. Put the fabric shield cover back
9. Done!